Решил все таки отдельную тему создать.Один  GD раз загрузилась и то не сразу, а сейчас бегает по кругу. Может кто подсекажет в меню BIOS
1- Load from Hard disk
2- Load from SDcard
3- Load from Ethernet
4- Load from Hard disk & bootp
5- Load from SDcard & bootp
6- Display MAC addresses
7- Reset

выбирать 2 или 5 ?

Весь лог вот такой:
SATA:  SATA0 [Link: no RDY]
      SATA1 [Link: no RDY]
## Booting image at ff836de0 ...
  Image Name:   aleboot.bin
  Image Type:   PowerPC U-Boot Standalone Program (uncompressed)
  Data Size:    8840 Bytes =  8.6 kB
  Load Address: 00200000
  Entry Point:  00201954
  Verifying Checksum ... OK
OK
DIP switch: 0x02
m41t11 Chip
No Prompt
Press ^B^I to enter into the Bios menu  0 Booting from NETWORK BOOTP
Hit any key to stop autoboot:  0
## Booting image at ff8390a8 ...
  Image Name:   gpioinit.bin
  Image Type:   PowerPC U-Boot Standalone Program (uncompressed)
  Data Size:    2185 Bytes =  2.1 kB
  Load Address: 00200000
  Entry Point:  00200620
  Verifying Checksum ... OK
OK
Watchdog Started
Waiting for PHY auto negotiation to complete...... TIMEOUT !
TSEC0: No link.
Waiting for PHY auto negotiation to complete...... TIMEOUT !
TSEC1: No link.

Using TSEC0 device
BOOTP broadcast request 1 in progress ---> 00:80:9f:b5:36:52